The wiring method of wrapping the wire around the screw is not stated. Often the grounding wire is wrapped around the cable as it enters the box. Bought a new outdoor fixture and it has a black, a white and TWO(?) Use this hook to go around the ground screw and then tighten the screw. Other methods also work well if installed correctly; one such method is a grounding clip that clamps the ground wire to the box. Protect wiring from nails and screws. that make electrical work code-compliant and safe. The key is using metal-to-metal connection. Wrap the bare or green wire from the ceiling light around the same screw. Is it necessary to wrap an electrical tape around an electrical receptacle (plug) after the tightening the wire screws? Part of the series: Ceiling Fans & Home Maintenance. If you can’t attach the wire back the way it was, wrap it around any available screw in the fixture that touches bare metal. I know to wrap the ground from the outlet to the ground screw , but what about the fixture's two copper wires? I was trying to replace a few electrical outlets around the house with new tamper-resistant ones. If you’re ready to go to work, keep reading. When I pulled one of the outlets out of the box, I noticed that 1) there was no ground wire anywhere, 2) two white wires were under the same screw and one single black wire on the other side. Sent from my iPhone using ET Forum Should you ever need to ground electrical outlets that have no grounding wire, don't worry—it is possible. You loosen the screw, separate the plate from the switch body (easiest to let gravity do the work; turn it plate-down and shake), insert the wire stripped to the proper length, then tighten down the side screw. How to Install a Ceiling Light Without a Place for the Ground Wire. The grounding wire nut shown has a hole in its top that makes installing a pigtail easier. Metal boxes I just bond the box. member to any wire to keep drywall screws and long trim nails from puncturing the insulation and causing a short. I noticed that he never wrapped the outlets with electrical tape, nor did he really tighten them into the box. ground wires.. Not sure what there's two and how do i connect these? In this case, you should pigtail all of the device grounds together and have one lead from the pigtail ground to the metal device fixture box and another lead used as a ground … Glue is an insulator, so if you glue the wire back on, it won’t act as a ground wire anymore. The following is a list of mistakes to Ground wires are spliced together and attached with a pigtail to the box and receptacle. Or wrap it around the screw and tighten the screw. Thanks in advance. Wrap the bare ground wire you attached to the electrical box around the green ground screw attached to the strap. See 250.8(1). Secure the ground wire. It works a lot like side-wiring, except you don't have to curl the wire around the screw. I recently had an electrician in my house replacing all my outlet from 2 pronged outlets to 3 pronged grounded outlets. Wire connectors, either crimp or wire nut types are not required to be listed for bonding and grounding when used to terminate grounding and bonding conductors. 1. This was a non-GFCI outlet … So I have an outlet with a black, a white and a ground (copper). Plastic pigtail and ground the device. Get needle-nose pliers and twist the very tip of the wire to make a hook. Electrical Outlets. But it states " continuity shall not be lost while removing the device" so by wrapping is okay and hit device or not, by using self grounding device.